Will four blanks fit across a 40-inch roll?
A studio needs four 10-inch blanks. On paper, a 40-inch roll looks like an exact fit. But if the edges take up even a fraction of that width, the fourth blank will run into the selvage. Before planning a cut, write down three measurements.
Start with the stitched area
Take a design that spans 144 stitches on 18-mesh canvas. At the nominal count, the stitched area spans 8 inches. If your frame and finishing method require an inch of clear ground on each side, the cut blank needs to be 10 inches wide. Change the margin and the cutting plan changes with it. The mesh calculator lets you try the same design at another count.
Measure between usable edges
Lay the ground flat and mark where the regular, usable grid begins and ends. Measure between those marks in several places along the piece. Record the narrowest usable width next to the overall width. For LoomTally’s 18-mesh white mono canvas, 40 inches is the development target for overall width. Usable width awaits measurement on a numbered sample.
Lay out one row before planning a batch
Four 10-inch blanks need at least 40 usable inches across the roll, plus any space your cutting method consumes. At a hypothetical 39 usable inches, only three complete blanks fit across. Sketch the row with the intended orientation and margins before multiplying by the length of the roll. Keep that sketch with the sample worksheet so the next cutting plan can use the same reference.